DTY-12S  New Features :

New design narrower 2.0mm 7075 aluminum main chassis to improved cornering speed.

New design graphite front lower arm.  Short/long wheelbase (+/-2.0mm) changeable by different direction of aluminum blocks.

New 7075 hardened aluminum lightweight 4 deg kingpin.

NEW single piece steering knuckle with pre-built POM insert and polished front wheel axle.

NEW design graphite stiff front brace for high traction track. 

New design graphite chassis side brace and t-brace for chassis reflex adjustment.

New design floating pod link brace.  Pod link position forward/rearward changeable for roll center adjustment.

New 12 thread holes carbon rear solid axle.  Fits for most spur gear from different brand.

New Purple anodized 7075 aluminum front suspension blocks, servo mounts, steering turnbuckles, motor mount, left bulkhead, center pivot block, rear solid axle and wheel hubs.

Features :

Super low CG design

Ultra strength pod design

Lightweight solid rear axle (spool)

Lightweight single clamp hubs

Rear pod down stop screw for easy setting

Easily adjustable rear spring

Easy to change rear ride height axle adjusters (kit contains 0.25, 0.50 ,0.75)

Delrin double disc dampers for equal damping control in all directions

Side springs above the chassis for easy to see adjustment

Super low Roll Centre rear pivot, Ball in a hole system for strength and super free motion. 

Lipo brace using a band to hold Lipo in place for quick and easy access, no tape required. 

Carbon Lipo battery stop

5mm pivot balls to spread the load of the rear end and offer the most support possible

Plastic side links for a super smooth pod motion. 

Aluminum servo mount.

7075 aluminum front lower bulkhead.  Short/long wheelbase adjustable.

High grade ball bearings.